Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sun Nov 18, 2018 7:02 pm
Cambodia Expats Online: Forum | News | Information | Blog
Cambodia's Most Popular Expat Community Forums: Breaking News | Blogs | Nightlife | Khmer Culture | Information | Living, Working & Moving to Cambodia
https://cambodiaexpatsonline.com/
Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Page 1 of 1
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sun Nov 18, 2018 7:09 pm
Yea, I liked watching that.,,,,, What was it about again.
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Fri Nov 23, 2018 9:42 pm
You might like this, or not.
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sat Nov 24, 2018 7:35 am
Not like. I had to watch it several times to try and understand what the story was about. I'm still confused.
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sat Nov 24, 2018 12:41 pm
meh,
I'll never understand these repressed blokes with unresolved mommy issues, that drool over the sight of colossal, swaying udders.
<glances sideways at Felgerkarb>
I'm more of an ass-man, myself. That's where the pleasure resides, gentlemen:
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sat Nov 24, 2018 1:27 pm
I'm an ass man too, Brody. But I like a nice round plump ass, the ones in your pics are too small and flat. Do you toss salad? I love to do that!
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sat Nov 24, 2018 1:39 pm
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sat Nov 24, 2018 8:53 pm
She's a good enough looking girl, her boob job is not well done, I'm not a fan of it to begin with, but with her thinner frame she should of went down a cup.
Feel free to post more pictures to prove me wrong, darknet might be better 
You're on the wrong continent Brody
Feel free to post more pictures to prove me wrong, darknet might be better Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sat Nov 24, 2018 9:51 pm
A bit of something for everyone, tits, donkey, but no tossed salad.
Re: Cutting Delrin/POM and Plywood on an 80w Chinese Lasercutter
Posted: Sun Nov 25, 2018 9:25 am
Seasquatch wrote: ↑Sat Nov 24, 2018 8:53 pm She's a good enough looking girl, her boob job is not well done, I'm not a fan of it to begin with, but with her thinner frame she should of went down a cup.
You're on the wrong continent Brody
That's correct Brody should be in South America, Mexico, or the Philippines for primo ass.